STANDARD FOOD TRUCK CONSTRUCTION & PRICING INFORMATION
All electrical is installed by a certified electrician and upon completion is inspected by Intertek and electrical is test to SPE 1000.
Permits are pulled for equipment
Piping is run and tested by a certified gas fitter
Propane is tested to CSA B149.1-10
Once equipment is installed, a secondary inspection is performed and the Food Truck is inspected and a permit is received from the British Columbia Safety Authority.
Fire Suppression (if required) is Installed by a third party certified contractor
Floor is covered in 1/8” aluminium checker plate
Walls and ceiling are covered in a high heat insulation
Ceiling is covered with a powder-coated white aluminium
Walls are covered in quilted stainless steel
Water tanks are potable water approved CSA
All water lines, taps, fittings, water pumps are NSF
All counter frames are manufactured from stainless steel
All counters and equipment are closed at the bottom with kick plates and sealed.
All equipment is certified.
The only wood used in the construction process is in the sub-floor (if required) and is completely sealed off.
APPROXIMATE FOOD TRUCK PRICING
Used Grumman Step Van (approximate price) $10,000 – $15,000
Interior Conversion $1,350/lin.ft.
Strip van of unwanted shelving & cabinets (within reason)
Rough layout of equipment and counter locations to determine location of cut-outs for service window, roof vents, hot water heater & other required vents
Framing of walls & roof with 1” square aluminium tubing after vent holes are cut out
Lay down tongue & groove plywood sub-floor if required. NOTE: This is the only wood used in the manufacturing of an Apollo Food Truck
1/8” aluminium checker plate is laid and sealed
Insulate walls & ceiling with 1” high heat insulation board
Ceiling is skinned with white powder coated aluminium sheet
Walls are skinned with 304 #4 quilted stainless steel
Fabricate service counter to suit
3 roof vents
Fabricate and install aluminium service window complete with gas spring lifters and interior latches
Install fluorescent lighting on ceiling as required
Install power panel c/w breakers and outlets as required and as layout will allow
Permit is pulled for electrical and completed by a licensed electrician
All electrical is inspected and approved by Intertek
One year parts & labour on all work performed by Apollo Custom Manufacturing.
Apollo does not carry any warranties on equipment that is not fabricated and installed by Apollo. All equipment installed has a transferable manufacturers or supplier warranty. Any warranty issues with equipment must be dealt with the original manufacturer.
Apollo does not carry any warranties on trucks supplied by the customer or on trucks sourced by Apollo.
Interior window $785
2 pce interior Plexiglass or screen sliders in service window opening plus vent screens
Generator compartment c/w sliding frame $2,200
Generator to be sized and quoted based on requirements.
Generator install if required $ 1250
Gas lines and electrical
Battery mounting and wiring
Complete Water System $6,150
Sttainless Steel cabinet frame
Stainless steel counter – 304 #4 s/s
Stainless steel cabinet doors – 304 #4
30 gallon fresh water capacity
45 gallon waste water capacity
6 gallon suburban propane fired hot water heater
Shurflo on Demand water pump
Triple ware wash sinks – deep – each c/w hot & cold mixing faucet
Hand wash sink – 9.5”x10.5”x6” deep – c/w hot & cold mixing faucet
City water connection
Waste water drain hose
Hand Tower Dispenser
Hand Soap Dispenser
Complete Propane System $5,400
Under carriage propane tank
High rating BTU Twin Stage regulator
¾” Black iron piping to all appliances
Shut offs at all appliances
Permit is pulled for propane and is inspected and approved by the B.C. Safety Authority
Inspection label is provided
Exhaust Hood $4,500
Price is based on approx. 6ft hood with commercial exhaust fan
If a longer hood is required – add $400 pre lft.
Stainless steel hood & shroud
Stainless Steel grease filters
Stainless steel grease tray
Roof mounted exhaust fan
Fire Suppression $4,200 & up
Installed by a third party, certified installer who will be contracted to do the install.
Counters & Cabinets
Stainless Counters and Cabinets $350 per lin ft.
Stainless Steel tube frame
Stainless steel counter top
Shelves or storage doors below
Upper Cabinets $250 per lin ft.
18ga 304 #4 stainless steel cabinet
20ga 304 #4 stainless steel doors with latches
Interior & Exterior shelving $100 per lft.
Bulkhead if required $2800
Price includes equipment – Install & counter if required. All cooking equipment converted to propane.
Standard 19cu.ft refrigerator/freezer $850
Small chest freezer $485
27″ sandwich fridge $2,695
48″ sandwich fridge $3,850
60″ sandwich fridge $4,175
Single Door Patriot Cooler $1,650
Double Door Habco Cooler $2975
36″ Refrigerated Chef Base $4,400
48″ Refrigerated Chef Base $4,950
Full size steamer/warmer $1,600
Double steamer/warmer $3,200
Triple steamer/warmer $4,800
(All steamers have water fill lines & drains. Does not include pans.)
24″ US Range Imperia $4,650
(24″ griddle top & space saver oven)
36″ Range $4,475
(24″griddle, 2 burner stove top, 36″ oven)
36″ US Range $5,150
(36″ griddle, 36″ oven)
36″ Range $4,475
(6 burner stove top, 36″ oven)
Blodgett Full Size Convection Oven $4200
Gyro Machine $3,160
Bakers Pride Pizza Oven $6,800
Double 15-½” Krampouz Crepe griddles $2,480
40 lb Deep Fryer – 2 basket $2,100
18″ Griddle – Volrath $1,850
24″ Griddle – Volrath $2,650
48″ Griddle – Volrath $3,575
18″ Char Broiler – Volrath $1,980
24″ Char Broiler – Volrath $2,450
36″ Char Broiler – Volrath $3,100
48″ Char Broiler – Volrath $3,375
Poatato Cutter – heavy duty 3/8″ cut – wall mounted $420
2 Burner Stove Top $1,250
4 Burner Stove Top $1,975
Any other equipment is available and will be quoted upon request
INFORMATION & PDF DOWNLOADS
PRICING & CONSTRUCTION INFORMATION
ALL PRICING IS IN CANADIAN DOLLARS
FOOD TRUCK EXTERIOR PDF DOWNLOADS
FOOD TRUCK INTERIOR PDF DOWNLOADS
Basic Grumman Van Floor Plan
Water System Layout
Grumman Van - 14' x 7' - Floor Plan A
Grumman Van - 14' x 7' - Floor Plan B
Grumman Van - 14' x 7' - Floor Plan C
Grumman Van - 92" x 191" - Floor Plan
Kick plates are custom manufactured to suit equipment once it is installed and are included in equipment pricing.
All stainless steel used is 304 #4 and 2B stainless steel.
All water system parts are NSF and/or CSA approved.
All propane parts & equipment are UI and/or CSA approved.
All prices listed are subject to change without notice.
Any extra work performed after original quote has been accepted will be charged out at $95 per hour plus materials.
TERMS & CONDITIONS
50% deposit plus applicable taxes with order.
A draw of 20% plus applicable taxes when work is approximately 50% complete.
Balance due in full at completion and before any Food Truck is shipped or picked up. Please allow enough time for the transfer of funds to be completed on, or prior to the actual pick-up or shipping date.
As all mobile food units are custom made specifically for the intended application of the purchaser, deposits are non-refundable. Apollo will at its discretion attempt to find a secondary purchaser with a standard 20% reassignment fee deducted from any deposits or payments made prior to the default. There is no guarantee Apollo will find a secondary purchaser.
If a truck is to be purchased by Apollo, the purchase price and any mechanical work is to be paid in full by the customer at the time of purchase or work performed.
Standard manufacturing time for a food truck is approximately 12-20 weeks from the date of the initial 50% deposit. The initial deposit guarantees a placement in the work queue but may not necessarily create the commencement of the manufacturing process of the mobile food unit at the same time.
Apollo cannot be held responsible for the availability of equipment & supplies from outside suppliers.
Truck owners must have a minimum of Storage Insurance on any vehicle left at Apollo.
Apollo Custom Manufacturing will not be held responsible for any damage or theft to customer vehicles.
Apollo Custom Manufacturing Ltd. carries a NON-TRANSFERABLE LIMITED WARRANTY on its mobile food units for one year from the date of completion.
During the warranty period, if any Apollo manufactured part should fail due to defect, it will be repaired or replaced free of charge once written authorization from Apollo has been given.
If Apollo is not able to inspect the requested repair, the mobile food unit may be taken to the nearest Apollo approved facility appropriate for the requested repair. A repair technician will then inspect and provide an estimate of the requested repair(s). Upon Apollo receiving the repair estimate and discussing with the repair facility the intended repair procedure, at its discretion Apollo will then authorize the repairs and provide payment for said repairs. No repair work is to begin without written authorization from Apollo.
Warranty on all internal or external equipment that is supplied by Apollo but not manufactured by Apollo carries its transferable original manufacturers or suppliers in-house warranty policy. All equipment repairs requested on equipment that is not manufactured specifically by Apollo will need to be initiated with the original equipment manufacturer or supplier in the case of a supplier warranty. Apollo is not responsible for and cannot conduct any repairs to any equipment that is not manufactured by Apollo.
All workmanship and equipment manufactured by Apollo is covered directly by Apollo.
All work or replacement parts must be authorized by Apollo prior to proceeding.
Other types of damage, but not limited to misuse or abuse, are not covered under the warranty of Apollo. Alterations, Misuse, Abuse or Negligence in operation void all Apollo specific warranties.
Apollo Custom Manufacturing Ltd. cannot be held responsible for any loss of business which may occur due to any part or equipment failure.
SHIPPING & CUSTOMS INFORMATION
Apollo handles all your shipping needs through our local logistics and brokerage companies and we are able to ship anywhere in the world.
We set up all the shipping for you and you pay the logistics company directly for the shipping costs. This will save you money. You will deal directly with the shipping company to track your order.
And even though it is rare, you will deal direct with any damages that may occur while in transit. It is the responsibility of you, the customer, to inspect your unit upon arrival and report any damages immediately to the shipping company, the carrier and Apollo. Please record any damages in writing as well as by photo.
Apollo will deal with all the customs clearances and brokerage so there is no worry about your order crossing the border. Apollo also covers the costs of the brokerage fees.
WE CAN SHIP YOUR NEW FOOD TRUCK
Apollo Food Trucks not only manufactures but we have the ability to ship the food truck to your location. No need for you to worry about the logistics of moving your food truck once it is complete. We can ship almost everywhere. Give us a call (778-565-1801) to discuss your shipping requirements.
Check out our other websites:
Apollo Custom Manufacturing • Your Custom Food Truck Manufacturer in Canada & USA • We Ship Worldwide • New & Used Food Trucks • Recycled Shipping Container Kitchens • Portable Self Contained Sinks